System setup menu
Use this menu to establish basic product settings. The System setup menu has several sub-menus. Each is described in the following table.
|
|
|
|
|
|
|
|
|
| Select the language for the control-panel display messages and the product reports.
|
|
|
|
|
|
| Select the size for printing internal reports or any print job that does not specify a size.
|
|
|
|
|
| A list of available media types appears.
|
|
| Select the media type for printing internal reports or any print job that does not specify a type.
|
|
|
|
|
|
| Select the default size and type for tray 2 from the list of available sizes and types.
|
|
|
|
|
|
| Select how the product should react when a print job requires a size or type that is not available or when a specified tray is empty.
|
| Select Wait forever to make the product wait until you load the correct media and press OK. This is the default setting.
|
| Select Override to print on a different size or type after a specified delay.
|
| Select Cancel to automatically cancel the print job after a specified delay.
|
If you select either Override or Cancel, the control panel prompts you to specify the number of seconds to delay. Press the Right arrow ( ) button to increase the time, up to 3600 seconds. Press the Left arrow ( ) button to decrease the time.
|
|
|
|
|
|
| After power on: Select how soon the product should calibrate after you turn it on. The default setting is 15 minutes.
|
| Calibrate now: Makes the product perform a calibration immediately. If a job is processing, the product calibrates after the job is complete. If an error message is displayed, you must clear the error first.
|
| Calibration mode: Determines the type of calibration that the product uses during the calibration process.
|
| ●
|
| Normal: The standard Calibration mode setting.
|
|
| ●
|
| Full: The extended Calibration mode setting (this calibration takes longer).
|
|
|
|
|
|
|
| Override out: If the product determines that a print cartridge is empty, you can continue printing until you notice a decrease in print quality.
|
| Stop at out: If the product determines that a print cartridge is empty, you must replace the cartridge before printing can continue. This is the default setting.
|
|
|
|
|
|
| The percentage threshold determines when the product begins reporting low toner. The message is either reported on the control-panel display or using the toner LED, if it exists. The default setting is 10%.
|
|
|
|
|
|
| Select Enable color to allow the job to print in either monochrome (black and white) or color depending on the specifications of the job.
|
| Select Disable color to disable color printing. All jobs will print in monochrome (black and white).
|
|
|
|
|
|
| Selects a version of the Courier font. The default is Regular.
|
|
|
|
|
|
| Select the level of contrast for the display. The default setting is Medium.
|
|
HP CP1510 System setup menu